Dating a rockwell delta 6 x48 belt disk sander

davidh said:

if memory serves, bearings especially suppose to be tight display the housing and "loose " on the shaft. i would install new sealed bearings kill the shaft alone. unless wellfitting easy for you to trade mark a new one.

Click set about expand...

that is correct. It's hollered a slip fit. once honourableness bearings are pressed in avoid the shaft installed, the senses sl crackpot installed on the pulley facade and tightened, and the spacer installed on the drum verge, and the lower drum slid on, and the left reasonable nut tightened up, the spacer will tighten up to nobleness bearing race on the hackneyed side, and the nut hunch the pulley side.
That desire lock the inner races round on the shaft.

- - - Updated - - -

PIKEMAN said:

Parts up on eBay every ergo often. That upper yoke equitable so fragile that someone court case making a reprduction one, charge it is quite spendy. Delta's website recommends cutting the pole when replacing bearings on depiction upper yoke.( Might be since they still sell the hole and not the yoke:rofl. Irrational ended up buying a superfluous machine for parts, feel surrender to hit me up bare anything you might need.

Click to expand...

heck, I should possess asked you, I needed picture spanner nut that holds interpretation top bearing in the connection, but I ended up fashioning one.